VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
6. Press to exit the menu.
7. Use Menu and to configure Display A and Display B (See Appendix B)
Power On Message
The power-on message can only be set via computer link, see the section called “Computer
programming” for details on how to set up a link with your computer.
The following instructions assume that you've already established a link using the BTECH
software from a computer running Windows, and that the BTECH software is already installed
and running.
Procedure 10.5. Setting the power-on message
1. Click Other in the menu bar; a dialogue box titled "Other" should have popped up.
2. In the box titled "Power on Message", there are two text fields representing the two lines
on your LCD. Enter the desired text in the fields.
3. Click Write to write your changes to the radio.
Make sure that menu item 38 is set to MSG, otherwise your message won’t be displayed.
See Chapter 5 Using the Menu System for details on how to navigate the menu.
Sometimes it takes the BTECH software more than one try to connect to your radio. If
you see a dialogue box popping up stating that you have a connection failure, close the
dialogue box and click read or write again.
To Next Page
Loading...
