VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Time Operation
In Time Operation (TO) mode, the scanner stops when it detects a signal, and after a factory pre-
set time out, it resumes scanning.
Carrier Operation
In Carrier Operation (CO) mode, the scanner stops when it detects a signal, and after a factory
preset time with no signal it resumes scanning.
Search Operation
In Search Operation (SE) mode, the scanner stops when it detects a signal.
To resume scanning you must press and hold the key again.
Adding or Remove Channels from the Scan List
You can configure channels to be added or removed from the scanning list on the fly.
1. Select the channel you want to add to the scan list.
2. Press the key to enter the menu.
3. Enter on your numeric keypad to come to scanning add (SC-ADD) mode.
4. Press the key to select.
5. Use the and keys to select if the channel will be added or removed from the
scanning list.
6. Press the key to confirm and save.
To Next Page
Loading...
