VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Chapter 3. - Basic Use
Power And Volume
Before we turn the power on, make sure you have attached the battery and antenna as
described in Chapter 1, Initial setup.
Turning the unit on
To turn the unit on, simply rotate the volume/power knob clockwise
until you hear a "click". If your radio powers on correctly there should be
an audible double beep after about one second and the display will
show a message or flash the LCD depending on settings for about one
second (see “38 PONMSG - Power on Message” in Appendix B, Menu
definitions). Then it will display a frequency or channel. If the Voice
prompt is enabled, the voice will announce "frequency mode" or
"channel mode".
To Next Page
Loading...
