VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Accessory jack
The accessory jack on the BTECH GMRS-V2 is a Kenwood compatible two (2)-pin design.
Figure 2.4. Typical 2 pin Kenwood headset configuration.
• To attach accessories such as headsets, speaker-mics or programming cables, align the connectors and
push in fully.
• The fit isn't always perfect on cheap or clone cables and connectors and may require a bit of force to
wiggle them in completely.
• Make sure the radio is off before attaching any accessories.
To Next Page
Loading...
