VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Battery Level Indicator
When the battery level indicator reads the battery is depleted. At this point the radio will start
beeping periodically as well as flash the backlight of the display and when voice prompts are
enabled, a "Low Voltage" announcement will be heard, indicating that you need to change your
battery or put your radio in the charger.
To get an Accurate Voltage reading you Press and Hold the button (for about 2 seconds),
the display will show the current voltage level of the battery.
Status LED
The status LED has a very simple and traditional design. When you receive a signal, it turns
green, when you transmit it turns red, and it's off in standby.
Side Key 1 [F]
Press [F] momentarily to start the broadcast FM receiver. Another momentary press turns the
broadcast FM receiver off. If a signal is received on the active frequency or channel while you
are listening to the broadcast FM, the receiver will open squelch to that frequency (as if
scanning) and remain there until the signal goes away; it will then switch back to broadcast FM.
Press and hold [F] to activate the alarm function. Press [F] (a short press) again to turn it off.
To send out a tone (more details in the section called “Tone-burst”.) Press the [F] key while
To Next Page
Loading...
