VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
Chapter 6. - Scanning
The BTECH GMRS-V2 features a built-in scanner for the VHF and UHF bands. When in
Frequency Scanning (VFO) mode it will scan in steps according to your set frequency step. In
Channel (MR) mode it will scan your channels, at approximately three frequencies per second.
Dual Watch is inhibited while scanning.
To enable the scanner, press and hold the key for about two seconds. Press any key to exit
scanning mode.
Scanning Modes
The scanner is configurable to one of three ways of operation: Time, carrier or search, each of
which is explained in further details in their respective section below.
Procedure 6.1. Setting scanner mode
1. Press the key to enter the menu.
2. Enter on your numeric keypad to come to scanner (SC-REV) mode.
3. Press the key to select.
4. Use the and keys to select scanning mode.
5. Press the key to confirm and save.
6. Press the key to exit the menu.
To Next Page
Loading...
