VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
A flashing "DCS" will be in the left status display to indicate the radio is in DCS scanning mode. In
this mode, whenever the radio is receiving an RF signal on the selected MR channel or VFO
frequency, the lower display will cycle through the DCS codes as they are being tested. Once the
value of the received DCS code is determined, the "DCS" indicator will stop flashing.
Press the key to save the scanned tone into memory then press the key to exit the
menu.
Don't forget to set VFO menu 10 back to OFF when the DCS tone is no longer required.
To Next Page
Loading...
