VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
When in Frequency (VFO) mode, select your desired receive frequency using the numerical
keypad, or using the and keys. After that, use the menu system to configure the finer
details of the channel you're wanting to program to memory, such as bandwidth, CTCSS or DCS
and more.
For more information on how to use the menu system see Chapter 5, Using the menu system
and Appendix B, Menu definitions. Information regarding how to set up CTCSS and DCS can be
found in Chapter 8, Selective calling.
1. Press the key to enter the menu.
2. Enter on the numerical keypad to get to RCH-AD.
3. Press to select.
4. Use the and keys to select an empty memory channel, or enter it directly on
the numerical keypad.
5. Press the key to confirm.
6. Press the key to exit the menu.
Switch your radio to Memory (MR) mode by turning the radio OFF, and then Press and Hold
button while powering on to test your new channel. If you would like to name your channel you
will need to do that from a computer. More on that in the section called “Computer
programming”.
To Next Page
Loading...
