SMART MATRIX FEEDER Error Messages
SMART MATRIX FEEDER 3-2
Excessive temperature on the motor of ULTRAFEEDER/ROLLING
FEEDER/UNIFEEDER device
Internal error on ULTRAFEEDER/ROLLING FEEDER/UNIFEEDER device
Target reached by ULTRAFEEDER/ROLLING FEEDER/UNIFEEDER device
Supply voltage lower than 15Vdc.
Error during the Learn process
Error during the Learn process (10 consecutive MINICYCLE o LONGCYCLE warning
messages)
Error during the Calibration process.
Press
to view further details.
ULTRAFEEDER/ROLLING FEEDER/UNIFEEDER device locked
Knot detection error by an UNIFEEDER device
The ULTRAFEEDER/ROLLING FEEDER/UNIFEEDER device does not detect yarn
feeding
An output peak has been detected by an ULTRAFEEDER device
A motor excessive torque has been detected by an ULTRAFEEDER/UNIFEEDER device
Counting error on coils accumulated on UNIFEEDER device. For more
information, please refer to the UNIFEEDER manual
To Next Page
Loading...