btsr SMART WARP - A6 - KEYCOD - Access Password to Programming Menus (KSETUP); A6 - KEYCOD - Access Password to LEARN Function (KLEARN)

Operation
- 3.16 - SMART WARP
KEYCOD - Access password to programming menus (KSETUP)
SETUP
$
$$
$
CONFIG
$
$$
$
KEYCOD
$
$$
$
KSETUP
This function allows entering a secret code (Keycode) to access the programming
functions of the system (Setup menu):
to activate the function.
to select the KSETUP function.
Enter the code of your choice (1 to 7 alphanumeric characters) using the following
buttons:
Increases the character where the cursor is positioned.
Decreases the character where the cursor is positioned.
Moves the cursor one position to the right.
To confirm and store the code which has been set.
! If no code is entered, the function is disabled and you will not be asked for
an access code when entering the SETUP menus.
KEYCOD - Access password to LEARN function (KLEARN)
SETUP
$
$$
$
CONFIG
$
$$
$
KEYCOD
$
$$
$
KLEARN
This function allows entering a secret code to access the self-learning function
(Learn):
to select the KLEARN function.
to activate the KLEARN function.
Repeat the same procedure described for KSETUP code setting.
! If no code is entered, the function is disabled and you will not be asked for
an access code when entering the LEARN function.
WARNING: If you set a password (KSETUP and/or KLEARN), it is
necessary to enter it each time you access the SETUP menu or
the LEARN function. If you forget the access code it will be
necessary to contact your BTSR reseller.