Operation
SMART WARP - 3.11 -
Operating Sequences
The
SMART WARP system allows you to carry out the following set of
functions:
!
Programming the parameters that affect the system operation, through a
number of interactive menus.
"
Activating a LEARN cycle, during which the sequence of yarns used by the
textile machine to produce the sample product, will be stored.
#
Continuously monitoring the machine production, indicating the errors
detected with respect to the sample “learnt” during the learning cycle (broken
or missing yarn, uncut yarn, etc.) and stopping the machine when the detected
errors exceed the set tolerances.
$%
Performing the sensor test as well as the communication test between
SMART WARP terminal and SM-DIN modules and between SM-DIN
modules and sensors, in case of failures.
When the system is turned on, after the initial diagnostic phase, SMART WARP
immediately gets into monitoring phase (CONTROL).
➩
➩➩
➩
To access the setting/changing menus of system operation parameters press and
hold for 3 seconds
➩
➩➩
➩
To activate (or reserve) a learning cycle press and hold
and
simultaneously
The following pages describe in details the various operating sequences
concerning the system programming and use.
To Next Page
Loading...
