Logamatic EMS – 6 720 801 386 2011/05
13
Principles of operation
4
4.3 Setting the operating mode
You can activate the operating mode directly by pressing the specified key.
Operating mode Key Explanation
Automatic
(recommended setting)
The switching program is active. The system will switch
over automatically between day mode and night mode
at a set time (switching point).
1)
At night the heating
system is operated with a reduced room temperature
(basic setting, night shutdown also possible).
The DHW is on during the day and off during the night
(basic setting).
The LED for the automatic button is lit up, along with the
LED for either day or night mode, depending on which
is currently active.
1) The automatic day and night modes correspond to the manual day and night modes. The only difference lies
in the automatic changeover.
Continuous heating
(manual day mode)
Factory setting: 21 °C Manual day mode is useful if you
want to heat outside the usual times. Automatic mode is
switched off.
The DHW is on (basic setting).
Only the day mode LED is lit up.
Permanently reduced
(manual night mode)
Factory setting: 17 °C The heating system is operated
with a reduced room temperature (basic setting).
Manual night mode is useful if you are occasionally
absent for long periods. Automatic mode is switched
off.
The DHW is off (basic setting).
Only the night mode LED is lit up.
Table 4 Explanation of the operating modes
The setting via the buttons specified applies to the heating circuits which are allocated
to the RC35 programming unit (so-called RC35 heating circuits, Æ page 26).
To set the operating mode for other heating circuits: Use User menu\operation
modes (Æ page 29).
To Next Page
Loading...
