Operation with the user menu
Logamatic EMS – 6 720 801 386 2011/05
36
5
7. Hold the button pressed down and turn the rotary selector to save the changed or new
program as User defined1 or User defined2.
The selected program, user defined1 or user defined2, is used from now on for that heating
circuit.
8. Select do not save to cancel.
5.6.5 Deleting a switching point
You can use delete switch point to delete switching phases you no longer require.
Ensure that you always delete two switching points for every switching phase (the start point and
the stop point) to ensure that the heating system reverts to night mode again.
1. Turn the rotary selector to select another switching point.
The selected switching point starts flashing.
2. Hold the button pressed down and turn the rotary selector to Yes.
The switching point is deleted.
3. Turn the rotary selector to switch between the days.
4. Press when you have finished making entries.
5. Hold the button pressed down and turn the rotary selector to save the changed or new
program as User defined1 or User defined2.
The selected program, user defined1 or user defined2, is used from now on for that heating
circuit.
6. Select do not save to cancel.
If you have changed the program and then do not press any button for five minutes, the
system assumes you have finished making entries and goes on to the next step.
If you have changed the program and then do not press any button for five minutes, the
system assumes you have finished making entries and goes on to the next step.
To Next Page
Loading...
Need help?
General
