Operation with the user menu
Logamatic EMS – 6 720 801 386 2011/05
26
5
5.3 Selecting a heating circuit
If your heating system is equipped with more than one heating circuit: prior to making some
adjustments, you will need to select the heating circuits(s) to which the settings should apply. Only
the heating circuits that are actually installed will be displayed:
Heating circuit
selection
Explanation
Heating circuit 1 Heating circuit without mixing valve
From heating circuit 2
1)
1) This function depends on the boiler used.
Heating circuits with mixing valve, i.e. with reducible flow
temperature
RC35 heating circuits all heating circuits, which are allocated to RC35, i.e. which do not
have their own remote programmer (Æ Fig. 2, [1], page 27); is only
displayed if several heating circuits are allocated to the RC35.
DHW DHW heating which is controlled by the RC35
DHW circulation
1)
DHW circulation pump which is controlled via the RC35
Solar
1)
Solar thermal system, if installed
Complete system All heating circuits, DHW, DHW circulation pump, and solar
Table 11 Heating circuits which could be installed in your heating system.
Recommendation: if several heating circuits are installed, it is sensible in most cases to
select RC35 heating circuits.
No heating circuit can be selected if there is only one heating circuit installed with no
DHW, no DHW circulation pump and no solar thermal system. No selection is possible
for boilers with only one heating circuit.
To Next Page
Loading...
Need help?
General
