Operation with the user menu
Logamatic EMS – 6 720 801 386 2011/05
24
5
4. Press the button to confirm the selection.
The USER\OPERATING MODE menu is opened.
The appearance of the display depends on the number of
heating circuits. If there is only one heating circuit installed
with no DHW and no DHW circulation pump, this screen will
not appear at all (Æ page 26).
Continue to the next step.
5. Press to select heating circuit 1.
6. To change the value, hold down the button (the value
starts flashing) and turn the rotary selector at the same
time.
7. Release the button.
The value stops flashing. The modified value is saved.
8. If you have carried out this example as practice only, make
sure that the original setting is retained.
To do so, repeat steps 6 and 7 if necessary.
Operation Result
Table 9 How to use the user menu (example)
heating circuit 1
heating circuit 2
heating circuit 3
domestic hot water
USER\OPERATING MODE
Which operation mode
should be used?
OPERATING MODE\HC 1
automatic operation
Which operation mode
should be used?
OPERATING MODE\HC 1
automatic operation
Which operation mode
should be used?
OPERATING MODE\HC 1
continuous heating
Which operation mode
should be used?
OPERATING MODE\HC 1
automatic operation
To Next Page
Loading...
Need help?
General
