EasyManuals Logo

Buderus Logano GE315 Installation And Maintenance Instructions

Buderus Logano GE315
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
45
We reserve the right to make any changes due to technical modifications.
Installation and maintenance instructions Logano GE315 • Issue 02/2006
6Maintenance
The water pressure in the system is too low, if the
pressure gauge needle falls below
(Fig. 51, item 2) the
green range (Fig. 51, item 3). You then need to re-fill the
heating system with make-up water (see chapter 3
"System start-up", page 33).
z Top up with water as required.
z Vent the heating system.
z Check the water pressure once more.
CAUTION!
SYSTEM DAMAGE
through temperature stresses.
z The boiler must only be filled via a filling
tap installed in the return pipe. (In the
UK the boiler must be filled used a
W.R.A.S. approved method).

Table of Contents

Other manuals for Buderus Logano GE315

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Buderus Logano GE315 and is the answer not in the manual?

Buderus Logano GE315 Specifications

General IconGeneral
BrandBuderus
ModelLogano GE315
CategoryBoiler
LanguageEnglish

Related product manuals