6 Maintenance
46 Installation and maintenance instructions Logano GE315 • Issue 02/2006
We reserve the right to make any changes due to technical modifications.
6.7 Inspection and maintenance
reports
The inspection and maintenance reports provide an
overview of the required inspection and maintenance
work.
Complete the reports during inspection and
maintenance.
z Sign all inspection work as completed and enter the
relevant date.
Inspection work
Page
(individual steps)
Comments
1. Check the general system condition
2. Check the system visually and for function
3. Check the fuel and water components of the system for:
– leaks
– visible signs of corrosion
– signs of ageing
4.
Check the combustion chamber and the heating surface
for contamination; shut-down the system for this step
page 38
5. Check the burner function See burner documentation
6. Check the flue gas routing for function and safety See burner documentation
7.
Check the water pressure and inlet pressure of the
diaphragm expansion vessel in sealed systems
page 44
8.
Check the water pressure and the inlet pressure in open
systems
page 44
9.
Check the function of the DHW cylinder and that of the
corrosion protection anode
See DHW cylinder
documentation
10. Check the control device settings
See control device
documentation
11.
Final check of the inspection work; document the
measurement and test results
Confirm the professional inspection with signature, date and company stamp
To Next Page
Loading...
Need help?
General