2003 Buell P3: Engine 3-5
HOME
TORQUE VALUES
ITEM TORQUE NOTES
Air cleaner bracket fasteners to air
cleaner
36-60
in-lbs
4.1-6.8 Nm page 3-21
Anti-rotation screws (lifter) 55-65
in-lbs
6-7 Nm Page 3-62
Crankcase 5/16 in. screws 15-19 ft-lbs 20-26 Nm Page 3-86
Crankcase, 3/8 in. screw 22-27 ft-lbs 30-37 Nm Page 3-86
Cylinder studs 10-20 ft-lbs 14-27 Nm Special method to tighten, Page 3-87
Flywheel - sprocket nut (for mea-
suring flywheel end play)
190-210 ft-lbs 258-285 Nm Page 3-73
Frame to rear isolator fastener 30-33 ft-lbs 41-45 Nm LOCTITE 262 (red), Page 3-17
Front isolator mounting bolt 63-70 ft-lbs 86-95 Nm LOCTITE 262 (red), Page 3-23
Front tie bar 30-33 ft-lbs 41-45 Nm LOCTITE 262 (red), Page 3-22
Gearcase cover screws 80-110
in-lbs
9-12 Nm Special pattern to tighten, page 3-72
Ground strap bolt to engine 30-33 ft-lbs 41-45 Nm Page 3-22
Master cylinder mounting screws 48-72
in-lbs
5-8 Nm LOCTITE 243 (blue), Page 3-20
Oil filter adapter 96-144
in-lbs
11-16 Nm LOCTITE 243 (blue), Page 3-60
Oil pressure signal light switch 50-70
in-lbs
6-8 Nm Page 3-60
Oil pump cover screws 70-80
in-lbs
8-9 Nm TORX, page 3-59
Oil pump mounting screws 125-150
in-lbs
14-17 Nm Page 3-59
Pinion shaft nut 19-21 ft-lbs 26-29 Nm Page 3-71
Piston jet TORX screws 25-35
in-lbs
2.8-4 Nm Loctite 222, page 3-82
Pushrod cover screw 30-40
in-lbs
3-5 Nm Page 3-62
Rear engine isolator engine to
crankcase
23-27 ft-lbs 31-37 Nm LOCTITE 243 (blue), Page 3-16
Rocker box cover screws 120-168
in-lbs
13.6-17.6 Nm Page 3-39
Rocker box to head bolts 135-155
in-lbs
15-18 Nm Different sizes, Page 3-39
Rocker box to head bolts 135-155
in-lbs
15-18 Nm Different sizes, Page 3-39
Rocker box to head bolts 18-22 ft-lbs 24-30 Nm Different sizes, Page 3-39
Side stand bracket 38-41 ft-lbs 51-55 Nm LOCTITE 262 (red), Page 3-16
Swing arm pinch bolt 17-19 ft-lbs 23-26 Nm LOCTITE 243 (blue), Page 3-16
Swing arm pivot shaft 24-26 ft-lbs 32-35 Nm Page 3-16
Top rear tie bar 30-33 ft-lbs 41-45 Nm LOCTITE 262 (red), Page 3-22
To Next Page
Loading...
