Information Code Description Corrective Action
I31
Displayed when a new drive is detected
after replacing hard drive.
Press the function button to rebuild the
RAID array.
I32
Displayed after replacing hard drive
when the RAID needs to be rebuilt in
Settings or formatting is necessary.
In Settings, either rebuild the RAID array
or format the hard drive.
I33
An error occurred in replication,
or synchronization between the
main TeraStation and the backup
TeraStation failed during the replication
configuration.
In Settings, navigate to Backup -
Replication and click Resync to execute
resynchronization. If the error is
displayed again, contact Buffalo
technical support for assistance.
I37 System recovery in progress. -
I38 System recovery is complete. -
I41
Press the function button on the front to
start the recovery process.
-
I42 Preparing to start the recovery process. -
I45 Recovery failed. -
I46
Data migration or conversion (RAID
migration) is in progress.
Don't turn off the TeraStation.
I47
Data migration or conversion (RAID
migration) is in progress.
Don't turn off the TeraStation.
I52
A new firmware version has been
released.
Update the firmware.
I54 A backup job has failed.
Make sure that the backup job is
configured correctly. Make sure that the
NAS is on and not in standby mode. If
the backup job still fails to run correctly,
check the status of the NAS, network,
and backup source and destinations.
I55
Authentication during recovery of
settings failed.
Settings can only be restored for the
TeraStation whose settings were
originally saved. To restore settings,
insert the USB memory device, turn
on the TeraStation while holding
down the init button on the rear of the
TeraStation, and restart the TeraStation.
Or, settings can be restored from
Settings with the TeraStation powered
on.
If the LED glows amber
When the power or info LED glows a steady amber, a new firmware version is available. Update the firmware to the
newest version.
Default Settings
Administrator's Name admin
Password password
Shared Folders
"share" (for both Windows and Mac computers). The recycle bin is enabled
on "share" by default.
121
To Next Page
Loading...