Burdick ELI 280 - Transmission Media Auto-Sync

CONNECTIVITY AND ECG TRANSMISSION
56
In either DHCP setting, the following wireless network parameters must be provided by the IT professional:
 Host IP
 Port Number
 SSID
 Channel Number
 Password or passphrase
NOTE: Addresses are always entered as 4 sets of 3 digits; therefore, an address of 192.168.0.7 must be
entered on the ELI 280 as 192.168.000.007.
If WEP wireless security is disabled on your access point, then set security (WEP) to None.
If WEP wireless security is enabled on your access point, the following wireless network parameters must be
configured in the device by the IT professional:
 Security: WEP
 WEP Key
 WEP Key ID
NOTE: The range for the WEP key is 0-3. If the range on your access point is 1-4, then 0 at the ELI 280
maps to 1 on the access point; 1 maps to 2 on the access point, etc.
If your wireless security environment is WPA or WPA2 (Wi-Fi Protected Access) then enter the following:
 Security: WPA-PSK or WPA2-PSK
 Passphrase:
NOTE: The passphrase length is limited to 64 digital Hex Value characters or 63 ASCII characters.
If your wireless security environment is LEAP then enter the following:
 Security: WPA-LEAP or WPA2-PEAP
 LEAP or PEAP User Name
 LEAP or PEAP Password
NOTE: LEAP user name and password are limited to 63 characters.
NOTE: Allow the ELI 280 several seconds to complete saving the WLAN configuration.
Transmission Media Auto-Sync
The ELI 280 automatically identifies the default transmission media. Connectivity options which have been
optionally purchased and installed will be available for default selection. The electrocardiograph will automatically
detect the communication device and automatically connect to it.