85
Cleaning the Thermal Printer
To clean the printer
1. Disconnect the power source.
2. Clean the exterior surface of the unit with a damp cloth using a solution of mild detergent diluted in
water.
3. After washing, thoroughly dry off the unit with a clean, soft cloth or paper towel.
To clean the print head
NOTE: Do not let soap or water come into contact with the writer, plugs, jacks, or vents.
1. Open writer door.
2. Lightly rub print head with an alcohol pad.
3. Wipe with a clean cloth to remove alcohol residue.
4. Allow print head to air dry.
5. Clean the platen by using adhesive tape. Apply the tape and pull it off. Rotate roller and repeat until entire
roller is clean.
6. Clean cue sensor photo detector.
Cleaning the Touchscreen
To clean the touchscreen
1. Disconnect the patient
2. Clean the exterior surface of the unit with a damp cloth using a solution of mild detergent diluted in
water.
3. After wiping, thoroughly dry off the unit with a clean, nonabrasive soft cloth or paper towel.
To Previous Page
Loading...