Need help?Do you have a question about the Burkert 1062 and is the answer not in the manual?
General| Brand | Burkert |
|---|---|
| Model | 1062 |
| Category | Industrial Electrical |
| Language | English |
Explains symbols used in the manual for warnings and notes.
Lists any existing restraints when the device is exported.
Details conditions for Ex certification validity and component combinations.
Lists improper uses that could lead to risks or damage.
Precautions when using in ATEX zones 21 or 22.
Safety measures for high-pressure installations.
Safety measures for electrical work.
Steps to avoid injury from various dangerous situations.
Provides addresses of international branches and website.
Outlines conditions for legal warranty based on product use.
Links to manuals and technical data sheets.
Describes where the position feedback is intended to be used.
Overview of construction, principle of operation, and components.
Explains the information provided on the device label.
Specifies operating conditions like temperature and humidity.
Details ATEX compliance with relevant standards and directives.
Lists standards to which CSA-approved devices conform.
Provides physical dimensions and material specifications.
Details device specifications across different versions.
Lists specific data for CSA-approved devices like pollution degree.
Covers electrical specifications, power supply, and consumption.
Safety warnings for assembly, including explosion and electrical risks.
Steps for replacing the top part of a 40mm actuator.
Instructions for attaching the position feedback to a pneumatic actuator.
Steps for fitting the position feedback with a stroke limiter.
Steps for fitting the position feedback with a stroke limiter.
Safety warnings for installation, including explosion and electrical risks.
Overview of electrical wiring procedures and considerations.
Wiring instructions for mechanical contact versions.
Wiring instructions for inductive 2-wire switch versions.
Wiring instructions for inductive 3-wire switch versions.
Wiring instructions for versions with two inductive 3-wire switches.
Wiring instructions for double inductive 2-wire NAMUR switch versions.
Wiring instructions for double inductive 4-wire switch versions.
Safety warnings for commissioning the device.
Procedure for adjusting cams for correct valve position detection.
Safety precautions for performing maintenance.
Instructions for cleaning the external surface of the device.
Lists available accessories and their item numbers.
Guidelines for safe packaging and transport to prevent damage.
Recommendations for storing the device to prevent damage.
Instructions for environmentally friendly disposal of the device and packaging.
To Next Page
