Burkert 1062 - Installation and Wiring; Installation Safety Instructions

27

English
Installationandwiring
 


Whenthe1062isusedinanATEX21or22zone,makesure:
Thatthecoveroftheelectricalpositionfeedbackisalways•
screwedshutbeforeoperatingthevalve.
Thatyoucheckthatthedeviceisnotsubjecttoaflowofairand•
dustthatmayresultinanaccumulationofelectrostaticcharges.
Otherwise,intallthedeviceinaconductivecover.
"TheNAMURswitchesonthe1062mustbepoweredbya•
voltagesourceofatypecertifiedforuseinexplosiveatmos-
pheresingroupsIIB/IICandtheircombinationmustbecompa-
tiblefromtheinstrinsicsafetypointofview."


Shutdownthepneumaticpowersourceanddepressurisethe•
pipesbeforecarryingoutworkonthedevice.

Beforestartingwork,switchoffthepowersupplyandsecureit•
topreventrestarting.
Observeallapplicableaccidentprotectionandsafetyregula-•
tionsforelectricalequipment.


Electricalinstallationcanonlybecarriedoutbyqualifiedand•
skilledstaffwiththeappropriatetools.
Installappropriatesafetydevices(correctlyratedfuseand/or•
circuit-breaker).


Takeappropriatemeasurestoavoidunintentionalactivationof•
theinstallation.
Guaranteeasetorcontrolledrestartingoftheprocesssubse-•
quenttotheassemblyofthedevice.