Burkert 1062 - Replacing Actuator Top Part (40 mm); Fitting to Pneumatic Actuator

17

English
Assembly
 




Preventtheprojectionoffluidsintotheactuator.•
A
B
Remove the top part→
of the actuator, "A",
by unscrewing itwith
the spanner available
in accessories (item
number639175).
Remove the top part
→
of the actuator rod,
"B",byunscrewingby
hand.
Screwthetoppartof→
the actuator supplied
with the 1062 to the
actuator size 40mm,
andtightenitusingthe
spanner(itemnumber
639175).
Replacing the top part of the actuator size 40mmFig. 5





Preventtheprojectionoffluidsintotheactuator.•


Preventtheprojectionoffluidsintothepositionfeedback.•


Preventcontactoftheelectronicswithametalcomponent(a•
screwdriver,forexample).
C
D
Ifthevalveisfittedwithanactuator→
size40mm,replacethetoppartofthe
actuator.Seeparagraph7.2.
Unscrewtheconepointsetscrew"C"
→
fromthe1062tounlock the dupli-
cationsystem"D"usingahexagonal
malespanner.
Carefully remove the duplication
→
system "D" from thehousing of the
1062.