Burkert 8041 - Page 18

18
Quick installation
Calibrate the full scale
of the installation?
→ Calibrate the full scale, see
chapter9.8.
→ Make
sure the uid
velocity>2m/s
and <10m/s.
No
yes
→ Set the relay output parameters,
see chapter9.9.
yes
No
The 10 bargraph LEDs
go ON?
Green LED ashes once?
→ Put the cover on the device
as described in Fig.16,
chapter8.3.
→ Tighten the 4 screws of the cover
in an alternating pattern.
The device is ready for use.
No, see chapter10.5
yes
english
Type 8041