Burkert 8041 - Product Description; Application Area

8
General information
4. GENERAL INFORMATION
4.1. Manufacturer's address and
international contacts
To contact the manufacturer of the device, use following
address:
Bürkert SAS
Rue du Giessen
BP 21
F-67220 TRIEMBACH-AU-VAL
You may also contact your local Bürkert sales oce.
The addresses of our international sales oces are available on
the internet at:
country.burkert.com.
4.2. Warranty conditions
The condition governing the legal warranty is the conforming use
of the device in observance of the operating conditions specied
in these Operating Instructions.
4.3. Information on the Internet
You can nd the Operating Instructions and technical data sheets
regarding the type8041 at: country.burkert.com.
5. DESCRIPTION
5.1. Area of application
The device is used to measure the ow of neutral or slightly
aggressive uids with a conductivity of more than 20µS/cm in
DN06 to DN400 pipes.
5.2. General description
5.2.1. Construction
The device comprises an electronic module and a PVDF or
stainless steel measurement sensor.
The ow sensor comprises two electrodes and a magnetic
system.
The connection of the device to the process is made depending
on the version, either by a G2" nut or a clamp.
Electrical connection is made via two cable glands on a 6-pin
terminal block.
The device requires an 18...36VDC power supply and has:
• a frequency output,
• a relay output,
• a 4...20mA current output.
english
Type 8041