Burkert 8041 - Device Installation Procedures; Installation Safety Precautions; Pipe Mounting Recommendations

19
Installation
8. INSTALLATION
8.1. Safety instructions
DANGER
Risk of injury due to high pressure in the installation.
▶ Stop the circulation of uid, cut o the pressure and drain
the pipe before loosening the process connections.
Risk of injury due to high uid temperatures.
▶ Use safety gloves to handle the device.
▶ Stop the circulation of uid and drain the pipe before loosen-
ing the process connections.
Risk of injury due to the nature of the uid.
▶ Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive uids.
Risk of injury due to electrical voltage.
▶ If a 18...36VDC powered version is installed either in a wet
environment or outdoors, all the electrical voltages must be
of max. 35VDC.
▶ Shut down the electrical power source of all the conductors
and isolate it before carrying out work on the system.
▶ Observe all applicable accident protection and safety regula-
tions for electrical equipment.
WARNING
Risk of injury due to non-conforming installation.
▶ The electrical and uid installation can only be carried out by
qualied and skilled sta with the appropriate tools.
▶ Install appropriate safety devices (correctly rated fuse and/or
circuit-breaker).
Risk of injury due to unintentional switch on of power supply
or uncontrolled restarting of the installation.
▶ Take appropriate measures to avoid unintentional activation
of the installation.
▶ Guarantee a set or controlled restarting of the process sub-
sequent to any intervention on the device.
WARNING
Risk of injury if the uid temperature/pressure dependency is
not respected.
▶ Observe the uid temperature/pressure dependency accord-
ing to the nature of the material of the tting used (see Fig.5
and Fig.6).
8.2. Installation onto the pipe
8.2.1. Recommendations for installing the
8041 on the pipe
english
Type 8041