Burkert 8041 - Device Adjustment and Commissioning; Commissioning Safety Instructions

30
Adjustment and commissioning
9. ADJUSTMENT AND
COMMISSIONING
9.1. Safety instructions
DANGER
Risk of injury due to electrical voltage.
▶ If a 18...36VDC powered version is installed either in a wet
environment or outdoors, all the electrical voltages must be
of max. 35VDC.
▶ Shut down the electrical power source of all the conductors
and isolate it before carrying out work on the system.
▶ Observe all applicable accident protection and safety regula-
tions for electrical equipment.
WARNING
Risk of injury due to non-conforming operating.
Non-conforming operating could lead to injuries and damage
the device and its surroundings.
▶ The operators in charge of operating must have read and
understood the contents of these Operating Instructions.
▶ In particular, observe the safety recommendations and
intended use.
▶ The device/installation must only be operated by suitably
trained sta.
WARNING
Danger due to non-conforming commissioning.
Non-conforming commissioning can lead to injuries and
damage the device and its surroundings.
▶ Before commissioning, make sure that the sta in charge
have read and fully understood the contents of these Operat-
ing Instructions.
▶ In particular, observe the safety recommendations and
intended use.
▶ The device / the installation must only be commissioned by
suitably trained sta.
NOTICE
The device may be damaged by the environment
Protect this device against electromagnetic interference, ultra-
violet rays and, when installed outdoors, the eects of the
climatic conditions.
When the device is energized and if the cover is open,
there is no protection against electric shocks.
english
Type 8041