Burkert 8798 - Rotating Linear Sensor: Series 26 xx;27 xx Valves

20
Installation
WARNING!
Risk of injury from discharge of medium and pressure.
If the direction of rotation is wrong, the housing interface may become
detached.
▶ Rotate the actuator module in the specified direction only
(series 2300 and 2301 or 27xx, see “Fig. 18”).
→ Series 2300, 2301 and 27xx with hexagon:
Rotate counter-clockwise (as seen from below) to bring the
actuator module into the required position.
→ Series 2300 and 2301 with key contour:
Rotate clockwise (as seen from below) to bring the actuator
module into the required position.
Special key
Open-end wrench
Series 2300 and 2301
with key contour
Series 2300, 2301
and 27xx with hexagon
Fig. 18: Rotating with special key / open-end wrench
8.2.4 Rotating the linear Remote Sensor
for process valves belonging to
series 26xx and 27xx
If the connecting cable cannot be fitted properly following installation
of the process valve, the Remote Sensor can be rotated contrary to
the actuator.
Fastening
screw (2x)
Actuator
Remote
Sensor
Fig. 19: Rotating the linear Remote Sensor, series 26xx and 27xx
english
Type 8798