Burkert SE35 - Commissioning; Commissioning Safety Instructions; Commissioning Procedure

60
Commissioning
9 COMMISSIONING
9.1 Safety instructions
Warning
Danger due to non-conforming commissioning.
Non-conforming commissioning could lead to injuries and damage the device and its surroundings.
▶ Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
operating instructions.
▶ In particular, observe the safety recommendations and intended use.
▶ The device / the installation must only be commissioned by suitably trained staff.
Protect this device against electromagnetic interference, ultraviolet rays and, when installed outdoors, the
effects of the climatic conditions.
9.2 Commissioning procedure
Before commissioning the device:
→ Enter the K-factor of the fitting used. See chap. 10.7.3.
→ Wire the device depending on the desired dosing mode. See chap. 8 and chap. 10.6.1 to 10.6.7.
→ If the digital inputs are used, place DI4 in the off-position before energizing the device.
→ Set the dosing mode. See chap. 10.7.5.
English
Type 8025 - 8035 - SE35 BATCH