BWT COVERDECK AX-IN - Wiring Diagram

PROTECTION & SAFETY
22 2020/06 - Indice de révision : A -
Code : 34560
Turn the key and hold it in position until the cover apron is round the axle. Validate
the pool open position by pressing . The leftmost LED goes out and the second
LED is lit up.
Turn the key to close the pool. Hold the key in position until the motor stops.
Turn the key in the other direction, giving it a twist. The 2
nd
LED blinks. The cover
rolls up around the axle. When the LED goes out, programming is complete.
NOTA BENE: The ends of travel can be deleted from memory in the event of a power outage:
‐ While the cover is in motion, either opening or closing.
‐ If the cover is partially open or partially closed.
In that event, simply reprogram the ends of travel as described previously.
Once the wiring has been checked and the ends of travel have been verified, pour the two-component gel
(self-levelling) into the connection box until the terminal block and wires submerged. Close the connection
box.
6. Wiring diagram
Light switch
Light switch
AC closed
AC open
AC closing.
opening
Shielding
Open
Close
Level
Motor
Motor