BWT COVERDECK AX-IN - Beam; Beam and Counterweight; Coverdeck Beam Mounting Unit with Sub-Coping Sealing Plate

PROTECTION & SAFETY
36 2020/06 - Indice de révision : A -
Code : 34560
BEAM
Product function
Hold and support the duckboarding.
Bear the weight of a person.
Guide the slat apron during opening and closing.
Correct minor masonry flaws.
Compliance with standards
Complies with the standard NF P90-308
Restrictions of use
The pool must comply with the stipulations of the AFNOR AC P90-321 agreement in terms of position tolerance.
The beams and brackets are compatible with Coverdeck automatic covers.
The beams and brackets are intended to support standard duckboarding from Procopi:
‐ Duckboarding 680x500
‐ Duckboarding 830x500
‐ Duckboarding 950x500
Safety recommendations and advice
Respect the assembly instructions.
The beams and brackets are designed to bear the weight of a person.
The gaps between the wooden duckboarding modules should be evenly distributed and less than 8 mm, as
required by the standard NF P90-308: Safety covers and fastening mechanisms.
1. Beam and counterweight
1.1. Coverdeck beam mounting unit with sub-coping sealing plate
Ref Description Qty
1 Sub-coping support plate 1
2
Beam mounting plate
1
3 Countersunk hex socket
screw M 8x20 A4 SS
5
4
Beam support shoe
1
5 Nut Q 8 A4 SS 4
6 Nylon bushing S 6x30 3
7 Adhesive gasket 1
8 Countersunk hex socket
screw M 8x16 A4 SS
4*
*2 extra screws per mounting unit if the
pit wall option is not selected