BYD Seal 2024 - Panoramic View System

WARNING
●
The AVAS pause switch can only
be used if there are no other
road users within a short distance,
and no audio prompt is needed
considering the surroundings (for
example, in a traffic jam or on the
motorway). As long as pedestrians
may appear around the vehicle,
the AVAS needs to be turned on.
●
If the vehicle is running at low
speed with AVAS turned off, it
is unable to alert pedestrians to
the approaching vehicle, which
may cause car accidents and even
casualties in severe cases.
●
If the AVAS prompt sound cannot
be heard when driving at a low
speed, stop the vehicle in a
relatively safe and quiet place,
open a window and drive in R
gear, then check whether you
can hear an audible prompt from
the front of the vehicle. If it is
confirmed that there is no sound,
contact a BYD authorized dealer
or service provider to deal with it.
Panoramic View System
With the ignition switched on, tap
Vehicle View on the infotainment system
homepage or press the button on the
steering wheel to access the panoramic
view.
●
Landscape mode:
●
Tap the front, rear, right, and left
areas of the vehicle. A single view
of the vehicle's front, rear, right, and
left images is displayed in the image
section on the right.
●
In the single front and rear
views, double-tap the image section
to switch to a 180° perspective
displayed in full screen.
●
Tap the radar icon
in the
panoramic view to enable the radar
display, and tap it again to disable.
When the radar display is enabled, a
warning is displayed as the vehicle is
approaching an obstacle.
●
Portrait mode:
●
Tap any two of the front, rear, right,
and left areas of the vehicle icon
in the lower left section. Views of
the two selected areas are displayed
in the upper and lower right image
section.
●
Tap the vehicle image switching
button in the lower left corner
to switch between transparent and
nontransparent vehicle images.
●
After the vehicle starts, the image
before last power-off is displayed
on the transparent panoramic view
screen. Foreign bodies shown may be
inconsistent with the actual ones in
the underbody and surrounding blind
areas. The underbody image update
will begin only after the vehicle has
started to run and will be complete
136