EasyManua.ls Logo

BYD Seal 2024 - Drivers Door Switches

BYD Seal 2024
218 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Auto/Intermittent wipers
The rain sensor automatically controls
the operation mode of wipers based on
the rainfall, and it is located in front
of the interior rearview mirror on the
front windshield inside the vehicle.
To use the automatic wiper function,
turn the wiper switch to the automatic
mode, go to infotainment touchscreen
VehicleGreeting and
toggle Auto Wiper on.
To use the intermittent wiper function,
turn the wiper switch to the automatic
mode, and toggle Automatic Wiper off
in infotainment touchscreen →
VehicleGreeting.
Turn the knob to change the rain
sensor sensitivity based on real-time
rain conditions. A total of four levels
are available.
Up: Reduce rain sensor sensitivity.
Down: Increase rain sensor
sensitivity.
Front windshield wipers and washer
To clean the front windshield, pull the
wiper switch lever backward (towards
the steering wheel) so that the washer
sprays washing fluid while the wipers
operate.
The washer spray will stop when the
stick is released, and the wipers will
operate twice then stop.
Driver's Door Switches
Power Window Switches
When the ignition is on, all the window
switches can roll up or down the
window. After the vehicle is powered
OFF, no power windows can be
regulated.
Window Control Switch on Passenger
Side
There are two gears of window control: ①
and ②, as shown in the figure.
Manual operation
Press/Pull the window control switch
to ① positions and hold (for vehicles
without anti-pinch function, directly
press/pull and hold the switch) to
lower/raise the window, and release
the switch to stop the window.
Auto lifting
Press or pull the window control
switch to position ② and release
71
03
CONTROLLER OPERATION

Table of Contents

Related product manuals