BYD Seal 2024 - Adjusting Front Seats

WARNING
●
After adjusting the seatback, lean
back to confirm the seatback is
locked. Seatbacks that are not
fully locked can cause personal
injuries in an accident or during
emergency braking.
●
Do not put the seatback down
while driving or riding in the
vehicle. This makes the shoulder
strap of the seat belt not properly
attached to the body. As a result,
occupants in the vehicle could hit
the strap in an accident, causing
injuries to the neck or other parts;
or they may slip out of the waist
belt, resulting in other serious
injuries.
●
Do not adjust the driver's seat
while the vehicle is in motion, as
unpredictable seat movement can
cause the loss of vehicle control.
●
Do not drive the vehicle until
occupants are seated properly.
CAUTION
●
Adjust the seat position before
fastening the seat belt.
●
While adjusting a seat, do not let
it hit against any passenger or the
luggage.
Adjusting Front Seats
Adjusting Front Seat with Power
Power front seat adjustments include
seat position, seating height*, seating*
and seatback angles. Choose the
following methods according to the
actual configuration of your vehicle.
① Seat position adjustment switch
●
Move the seat position adjustment
switch back or forth to slide the seat
backward or forward.
●
Move the front end of the switch up or
down to change the seat base angle.
●
Move the rear end of the switch up or
down to adjust the height of the seat
cushion.
② Seatback angle adjustment switch
●
Toggle the the seatback angle
adjustment switch front and back to
adjust the seat back angle.
REMINDER
●
Releasing the switch stops the
seat in this position. Do not
place anything under the seat as
this may prevent the seat from
operating.
●
Do not move the front seats too
far forward to avoid contact with
the roof or sun visor.
Lumbar Support Adjustment*
The seatback profile can be adjusted to
fit the curvature of the occupant's lumbar
spine.
●
Press the front or rear portion of the
switch to increase or decrease the
curvature.
●
Press the upper or lower portion of the
switch to extend the curvature up or
down.
61
03
CONTROLLER OPERATION