BYD Seal 2024 - Driver Attention Warning (DAW)

WARNING
●
ABS cannot work effectively under
the following conditions:
●
Tires with inadequate grip are
used (e.g., excessively worn tires
used on snow-covered roads).
●
The vehicle skids when driving
at a high speed on slippery
roads.
●
ABS is not designed to reduce the
braking distance of the vehicle.
Always keep a safe distance from
the vehicle ahead when:
●
Driving on slippery, muddy,
sandy or snowy roads.
●
Driving on roads with multiple
potholes or on uneven roads.
●
Driving on bumpy roads.
CAUTION
●
If the ABS fault warning light is
still on while the braking system
warning light is on, immediately
park the vehicle in a safe place.
It is recommended to contact a
BYD authorized dealer or service
provider.
●
In this case, if brakes are applied,
the ABS will not work and the
vehicle will become extremely
unstable.
●
ABS does not reduce the time
and distance required to stop the
vehicle. This device only helps you
control steering when braking.
Please always keep a safe distance
from other vehicles.
●
ABS cannot prevent skidding
caused by sudden direction
change, such as trying to make
a sharp turn or change lanes
suddenly. Always drive carefully at
CAUTION
a safe speed, regardless of road
and weather conditions.
●
ABS does not prevent decrease
in stability either. When applying
the brake in an emergency, the
steering should be moderate. A
large or sharp turn during the
driving can cause the vehicle to
swerve into oncoming traffic or
run off the road.
●
When driving on wet or soft
or uneven roads (such as
waterlogged concrete roads,
waterlogged epoxy painted roads,
sandy roads, snowy roads),
vehicles equipped with ABS may
require longer braking distances
than vehicles without ABS. In such
cases, reduce the vehicle speed
and keep a greater distance from
other vehicles.
Driver Attention Warning
(DAW)*
Driver attention warning (DAW) system
evaluates the driver's degree of fatigue
by the vehicle operation status such
as steering wheel angle, break, gear
and lane-changing. The driver would be
alerted by popups and voice prompt
according to the evaluation results to
ensure driving safety.
Driver Attention Warning (DAW ) is
enabled by default when the vehicle is
powered on.
How to Use
With the vehicle powered on, set the
warning in infotainment touchscreen →
→ ADAS → Driving Assist → Driver
Attention Warning (DAW). For safety
considerations, the setting is valid on the
144