●
When you reverse the vehicle, a
reversing image will be displayed
on the infortanment touchscreen
automatically.
●
After reversing ends, the interface will
be restored.
REMINDER
●
The safety lines for reversing are
only for distance reference in no-
load condition of the vehicle.
●
For your driving safety, when the
reversing image is displayed, all
buttons will be disabled except
some volume and phone related
buttons.
WARNING
●
The parking assist system ceases
to operate when the vehicle is
moving forward at over 10 km/h.
●
Do not place any articles within
the sensors' working range.
●
To prevent sensor malfunction, do
not wash the sensor area with
water or steam.
Reversing Radar Power Switch
●
To enable or disable the reversing
radar system, go to infotainment
touchscreen →
→ ADAS → Parking
Assist.
●
When the ignition is on and EPB is
released, the parking assist system is
enabled automatically.
●
When enabled, the system raises an
alarm if obstacles are found around
the vehicle; when disabled, it does not.
Sensor Type
●
When the sensor detects an obstacle,
an image is displayed on the
infotainment touchscreen* according
to the location of the obstacle and its
distance from the vehicle.
●
When the driver conducts parallel
parking or reverse parking, the
sensor measures the distance between
the vehicle and the obstacle
and communicates this information
through the infotainment touchscreen
and the speaker. Be aware of the
surroundings when using this system.
① Front right sensor
② Front left corner sensor
③ Rear right corner sensor
④ Rear left and right middle sensors
⑤ Rear left corner sensor
138
To Next Page
Loading...
