3. Insert the latch into the buckle until it
clicks, and then pull it back to make
sure it is firmly locked. Do not fasten
the belt with any part of the strap
twisted.
4. Adjust the height of the (front)
seat belts for optimum comfort and
protection.
① Press the adjuster release button.
② Move the adjuster up or down to the
intended position and release it.
5. Pull the shoulder belt firmly to check
that the adjuster is locked.
WARNING
●
The shoulder belt should cross
the center of the shoulder. The
seat belt should be far from the
neck and not liable to slip from
the shoulder, otherwise, it cannot
function well in the event of
emergency braking or accident,
and may even cause severe injury.
●
The lap belt should be positioned
as low as possible around the hips
to avoid serious injury due to the
intense lap belt forces against the
abdomen in an accident.
●
The seat belt should be fitted tight
to the body for better protection.
6. Unlock the seat belt.
●
Press the red unlock button on the
buckle. The latch plate pops out, and
the seat belt automatically retracts. If
the seat belt does not retract smoothly
and automatically, pull it out and
check whether it is twisted.
REMINDER
●
The method of wearing a rear
seat belt is the same as that
for a front seat belt. For normal
functioning of the rear seat belt,
please ensure that its latch is
inserted into the corresponding
buckle during use. The driver
13
01
SAFETY
To Next Page
Loading...
