20 cab Produkttechnik GmbH & Co KG
M4
2. General Safety Instructions
CAUTION !
- The printer is built exclusively to print die-cut labels, continuous media, and
similar materials as listed in Technical Specifications in Chapter 1.
- Connect the printer to an outlet with the correct voltage!
The printer is configured for voltages of 100 to 240 V.
Connect only to a power outlet with a grounded contact.
- The printer must only be connected to devices which have extra low voltage.
- Power must be OFF before plugging in any accessory, connecting to a
computer and before performing any maintenance on the printer. Also turn
the power off on all appliances before disconnecting from the printer.
- Do not expose the printer to any moisture, or use in damp or wet areas.
- The printer will operate with the cover open if necessary. This is not
recommended, as it might allow debris to collect on the printhead surface. If
the printer must be operated with the cover open, extra care must be taken
to avoid allowing hair, jewelry, clothing, etc. near the moving parts.
- During the print process the printhead will become hot. Use extra caution
when touching the printhead. Do not touch the printing surface of the
printhead with you hand!
- Any adjustments or repairs which are not described in this manual, should
only be carried out by an authorized service technician.
WARNING !
To avoid possible electric shock, do not open the backside cover!
3. Unpacking
Delivery Contents
Please inspect the printers packaging and contents immediately after receipt for
possible damage during shipment.
NOTICE !
Be sure to preserve the original packaging for possible later shipment!
The shipping container will contain the following standard components:
- Thermal Transfer Printer
- Cardboard Core for the transfer ribbon rewinder
- Tear-off Plate (M4/200 and M4/300 only)
- Rewind Guide Plate (M4/200R and M4/300R only)
- Dispense Plate and optional Present Sensor PS8
(M4/200P and M4/300P only)
- Power Cord
- CD with documentation und printer driver
- CD with label software CABLABEL LITE
2. General Safety Instructions / 3. Unpacking
To Next Page
Loading...
