CAB M4 - Print Parameters Overview

72 cab Produkttechnik GmbH & Co KG
M4
Parameter Meaning
Heat level Basic adjustment of the heat
intensity
Default : 0
Print speed Basic adjustment of the print
speed
Default : 100 mm/s
Transfer print Basic selection of thermal
transfer mode / direct thermal
mode
Default : On
Warn level Setting the threshold diameter
ribbon for the warning message
"ribbon end"
Default : Off
Label sensor Method of label sensing
Default : Gap sensor
Tear-off mode Activating a small feed to the
tear plate at the end of a print
job
Default : Off
Backfeed Method of backfeed when
using peel-off mode or the cut
mode
Default : smart
Error - Reprint Selection of automatically
reprinting a label after a
correctable error has been
fixed.
Default : On
Print Parameters
Setup
Print Parameters
Selection
-20 ... +10
M4/200 : 50-150 mm/s
M4/300 : 50-100 mm/s
steps of 25mm/s
On
Off
Off
32 ... 74 mm
Gap sensor
Bottom reflect
Endless media
On
Off
smart
always
On
Off
Table 8d Overview of the "Print parameters" Folder
8. Printer Configuration