CAB M4 - Overview of Configuration Parameters

65cab Produkttechnik GmbH & Co KG
M4
Setup Local settings Country
Time zone
Daylight saving
Set date
Set time
Machine param. Printhead pos. X
Printhead pos. Y
Tear-off pos.
[Demand sensor]
[Cutter]
Time Powersave
Debug mode
Print parameters Heat level
Print speed
Transfer print
Warn level ribbon
Label sensor
Tear-off mode
Backfeed
Error-Reprint
Barcode error
Pause-Reprint
Width ASCII dump
Interfaces Character set
RS-232
Ethernet
Security PIN
[...] The parameter "Demand sensor" is only accessible for the P-version
printers with Present Sensor installed.
The parameter "Cutter" is only accessible after installing an optional
cutter.
Table 8a Overview of the Configuration Parameters
Overview of the Configuration Parameters
8. Printer Configuration