CAB M4 - Connection to a Computer

28 cab Produkttechnik GmbH & Co KG
M4
1
2
Connection to a Computer
As standard, the printer is equipped with a serial RS-232-interface with a 9 pin
connector (5) and an USB interface (6) for local operation. Moreover the printer
has an ethernet interface (4) for operation in a network.
CAUTION !
Make sure that all connected computers and their connecting cables are
correctly grounded.
5
4
Fig. 5b Computer connection
5. Installation
3
6
USB Interface
Connect the computer with a A-B-cable (3) to the USB interface (6) of the
printer.
After switching on the printer, the computer detects the new hardware
component and ask you to install the printer driver. If you want to work with
CABLABEL, the installation of the Windows Printer Driver is not necessary
because CABLABEL has own internal drivers. Otherwise install the Windows
Printer Driver.