27cab Produkttechnik GmbH & Co KG
M4
5. Installation
CAUTION !
Make sure the printer is located where the unit or the operator cannot
come in contact with water. Otherwise it could cause damage to the
printer.
1
2
5. Installation
Connection to Power Supply
The printer is equipped with a wide range power unit (100-240V~), so it is
possible to use the printer both with a voltage of 230V~/50 Hz and with a
voltage of 115V~/60 Hz without making changes to the printer.
CAUTION !
Make sure the power switch (1) is in position "
O
" (OFF) before
connecting the printer to a power supply !
Fig. 5a Power supply
Insert the power cable supplied in the accessories carton into the power supply
connector (2) and contact the cable to a grounded outlet.
To Next Page
Loading...
