51cab Produkttechnik GmbH & Co KG
M4 7. Media Loading
4. Slide a cardboard core (1) onto the ribbon take up hub (2). Clamp the
core by rotating the knurled knob (3) counter-clockwise.
5. Feed the transfer ribbon along the path as shown in figure 7l and attach it
to the cardboard core (1) using a piece of tape or a label.
6. Turn the ribbon take up hub (2) counter-clockwise until the ribbon is taut
and without any wrinkles.
7. Rotate the printhead lever (7) counter-clockwise until it stops, thereby
locking the printhead into position.
Fig. 7l Path of Transfer Ribbon
1 27
To Next Page
Loading...
