CAB M4 - Page 57

57cab Produkttechnik GmbH & Co KG
M4 8. Printer Configuration
- Click on the parameter you want to change. In the right part of the window
the current setting is shown. Click on that area.
- Depending on the parameter type you can select the new setting from a list
or enter the new setting directly.
- When you have finishing all settings, click "Send Settings".
The new settings will be uploaded to the printer.
NOTICE !
If you leave the cab Setup Utility whithout clicking "Send Settings" all
parameter changings are cancelled.
- The changings may be checked by clicking again "Read Settings".
Fig. 8c Changing the parameter "Country"