©2020 CAE 905K640152 v1.1 39
Setup
Step 8: Place Ares’ Wig
To place the wig on Ares’ head:
a. Remove the wig from the packaging, and remove all packing materials.
b. Place the wig on Ares’ head. If the wig needs to be adjusted, see the following steps in the
Adjust the Fit of the Wig section.
Placing the Wig
To adjust the fit of the wig:
a. Remove the wig from Ares.
b. Turn the wig hair side down.
c. Locate the adjustment strip.
d. Locate the adjustment hooks towards both ends of the adjustment strip.
e. Use the adjustment hooks to pull the wig tighter by inserting them into loops closer to
the center.
f. Loosen the wig by moving the adjustment hooks to loops further from the center.
Tightening the Wig Loosening the Wig
To Next Page
Loading...
