©2020 CAE 905K640152 v1.1 35
Setup
Step 4: Prepare Ares for Arms
The following tools and hardware are included:
• One (1) Phillips screwdriver
• Two (2) arm screws
• Two (2) joint spheres
To prepare for the arms:
a. Remove the IM/IO pads from both arms and set them aside.
b. Insert a screw into the flat side of a joint sphere. Repeat for the other joint sphere.
Arm Screws with Joint Spheres
c. Insert a joint sphere and screw assembly into the mounting hole in each arm.
Attaching Ares’ Arms
To Next Page
Loading...
