Cal Amp VIPER SC+ 100 series User Manual

Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 145
APPENDIX C – VIPER SC+™ REGULATORY CERTIFICATIONS
Domestic and International Certifications
Model Number
Frequency Range
FCC
IC (DOC)
European Union
EN 300 113
Australia / New
Zealand
140-5018-500*
140-5018-501*
136 - 174 MHz
NP4-5018-500
773B-5018500
140-5018-502
140-5018-503
136 - 174 MHz
NP4-5018-500
773B-5018502
140-5018-600
140-5018-601
142 - 174 MHz
1588
ACMA AS/NZS 4925-
2004 (Spectrum
Impact Assessment)
140-5028-502**
140-5028-503**
215 - 240 MHz
NP4-5028-502
773B-5028502
140-5028-504
140-5028-505
215 - 240 MHz
NP45028504
773B-5028504
140-5048-300*
140-5048-301*
406.1 - 470 MHz
NP4-5048-300
773B-5048300
140-5048-302
140-5048-303
406.1125 - 470 MHz
NP4-5048-300
773B-5048302
140-5048-400
140-5048-401
406.1125 - 470 MHz
1588
ACMA AS/NZS 4925-
2004 (Spectrum
Impact Assessment)
140-5048-500*
140-5048-501*
450 - 512 MHz
NP4-5048-300
773B-5048300
140-5048-502
140-5048-503
450 - 512 MHz
NP4-5048-300
773B-5048302
140-5048-600
140-5048-601
450 – 512 MHz
1588
ACMA AS/NZS 4925-
2004 (Spectrum
Impact Assessment)
140-5098-304
140-5098-305
880 - 902 MHz
NP45098304
773B-5098304
140-5098-500*
140-5098-501*
928 - 960 MHz
NP4-5098-500
773B-5098500
140-5098-502**
140-5098-503**
928 - 960 MHz
NP4-5098-502
773B-5098502
140-5098-504
140-5098-505
928 - 960 MHz
NP45098504
773B-5098504
UL Certification
All models UL approved when powered with a listed Class 2 source.
This device is suitable for use in Class I, Division 2, Groups A, B, C, and D or non-hazardous locations
only.
Installation
This device is intended for installation only in a RESTRICTED ACCESS LOCATION per EN60950-1:2006.
* Obsolete models
** End of Life in 2014

Cal Amp VIPER SC+ 100 series Specifications

General

Brand	Cal Amp
Model	VIPER SC+ 100 series
Category	Network Router
Language	English