Cal Amp VIPER SC+ 100 series User Manual

Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 60
Delete Entry — To delete an entry, click the Delete Entry button, and then enter the RF MAC address of the unit that
you want to delete. Then, click the Save button.
Figure 39 – Delete a static neighbor entry screen
Refresh — Click Refresh to update the information displayed in the Local Status section.
4.3.4. GLOBAL SETTINGS
Global Settings is the fourth (from left) tab of the RF Network Settings page. To navigate to this tab, select RF Network
Settings from the main menu and click Global Settings. This tab allows you to make several Global Settings for the RF
Network.
Note: Settings in this tab are only available when the Viper is in Router mode.
The Global Settings tab allows you to make changes for a single Viper or to the entire Viper network. It allows you to
make changes to remote units’ Neighbor Tables.
Figure 40 – RF Network Settings – Global Settings

Cal Amp VIPER SC+ 100 series Specifications

General

Brand	Cal Amp
Model	VIPER SC+ 100 series
Category	Network Router
Language	English