Cal Amp VIPER SC+ 100 series User Manual

Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C | Page 164
An IP packet whose source IP address originates from the RF network and is sent towards the Ethernet network will
have its source IP address replaced by the Ethernet IP address of Viper (2). Notice in this configuration the Ethernet IP
address for Viper (1) is considered private and the RF IP address for Viper (2) is considered private. The following figure
shows how packets will be modified as the packets pass through the network.
Figure 87 – Packet Flow, Ethernet and RF (Private)
In the following figure, the RF interface of Viper (2) is considered private. NAT is disabled for Viper (1). Viper (1)
changes the source address of the packet, making Viper (2) believe that the packet originated from the RF network.
Figure 88 – RF Interface (Private)

Cal Amp VIPER SC+ 100 series Specifications

General

Brand	Cal Amp
Model	VIPER SC+ 100 series
Category	Network Router
Language	English